[Elecraft] Macro for setup of K3S for WSJT

[RIchard Williams]

Bill,
Thanks for info; you know, I did not know about switching to Data A switches the input to line in.
I have a AM filter, but am not sure with band with FT8 uses, what advantage a wider filter  than the stock SSB filter has.
Dick,  K8ZTT 

Sent from Yahoo Mail ohave an Android 
 
  On Tue, Dec 12, 2017 at 23:09, Bill Frantz<frantz at pwpconsult.com> wrote:   My experience is that if you set wsjt-x to use rig control, just 
starting to monitor does most of the work. I end up in Data-A 
mode. This automatically sets the mic sel to Link In. I already 
have a macro to open up the bandwidth, which automatically sets 
the filter to my FM filter. My macro for bandwidth is :

  IS 1450;BW0230;

Note that this macro doesn't open up the bandwidth to the full 
4K, which I do by turning the knobs. The K3 remembers the last 
bandwidth I used, so I don't have to manually change it very often.

I hope this helps.

73 Bill AE6JV

On 12/13/17 at 8:58 PM, elecraft at mailman.qth.net (RIchard 
Williams via Elecraft) wrote:

>Before I beat my head against the wall (or re-invent the 
>wheel); does someone have a micro to setup the K3S (or K3) for 
>WSJT-X.  What I am looking for is:
> 1.  Set the mode to TX Data
>2.  Set mic sel to Line In
>3.  Set the filter to FL2 (2.7 KHz in my case)
>4.  Open up the pass band width to max
>I think that is it; but I might have missed something??
>Thanks,
>Dick, K8ZTT

-----------------------------------------------------------------------
Bill Frantz        | "The only thing we have to  | Periwinkle
(408)356-8506      | fear is fear itself." - FDR  | 16345 
Englewood Ave
www.pwpconsult.com | Inaugural address, 3/4/1933  | Los Gatos, 
CA 95032