[Elecraft] New K3S build filter placement

[Don Wilhelm]

Tom,

That should work fine.  Just set the menu (or easier still, use 
K3Utility) to set the proper filter widths and offsets.

73,
Don W3FPR

On 12/9/2017 8:24 PM, Tom Norris wrote:
> I have made my way to preparing to install the filters I purchased for the
> project. I have read (someplace) that I could place the filters on the RF
> board skipping the locations that I might later decide to add. With
> thoughts of possibly adding narrower SSB and data filters I am planning to
> install the FM 13Khz in FL1, the 2.8Khz in FL2, leave FL3 blank, install
> the 400hz in FL4 and leave FL5 blank. Are there any disadvantages to this
> approach? I'm thinking the FM 13Khz filter will allow me to dabble in FM
> and AM (I have typically not been a phone person)?