[Elecraft] BNC Connector on KX3

[Phil Kane]

On 8/23/2017 5:56 AM, geoffrey allsup wrote:

> I noticed this issue when I first assembled my KX3.  The simple cure
> for me after tightening the BNC a couple of times early on was to use
> a right-angle BNC adapter all the time.  No more problems, and the
> coax conveniently pays off to the rear of the rig :-)

I use that trick on all the BNC fittings on the preamps, filters, and
multicouplers in my receiving signal distribution system mounted on a
vertical backboard.  Makes connection much easier.

73 de K2ASP - Phil Kane
Elecraft K2/100   s/n 5402

>From a Clearing in the Silicon Forest
Beaverton (Washington County) Oregon