[Elecraft] BNC Connector on KXe

[Don Wilhelm]

Aaron,

The most likely cause is that the nut on the BNC jack has worked loose. 
It should be easy to tighten, although you will likely have to remove 
the 2 meter option (if you have it) and the KXAT3.
See page 25 of the KX3 Assembly Manual.
Use a wrench to tighten the nut, and while tightening the nut, put a BNC 
connector on the outside of the jack and hold it with pliers so you can 
torque the nut tight without damaging the BNC jack.

73,
Don W3FPR


On 8/22/2017 9:54 AM, Aaron K5ATG wrote:
> The BNC Connector on my KX3 has become loose, is there a way to repair it?