[Elecraft] [K2] Sensitivity Spec

[Steve Kavanagh]

I'm just trying to evaluate if I have the gain distribution right for a K2 used as an IF for a 10 GHz transverter, through a 2 m transverter mounted inside the QRP top.  The K2 manual gives a specification for the MDS but fails to define the bandwidth at which it is measured.  Sherwood's receiver table lists some measured values at 500 Hz bandwidth but fails to note whether the preamp is on or off for these measurements.  So I am not quite sure what the sensitivity should be.  

Can anyone clarify?

73,
Steve VE3SMA