[Elecraft] Some K2 notes after completion

[Robert G Strickland]

Anthony...

I wouldn't say it's a "basic" radio but rather that it is just about a 
state-of-the-art radio without bells and whistles. What the K2 does it 
does just about as well as any of the "modern" radios. You'll enjoy it 
more and more as you use it.

...robert

On 08/12/2017 14:00, Anthony Clare wrote:
> Hello all.
>
> I just wanted to pass along a few tidbits after the completion of my K2 (2
> months ago).
>
> First, I want to thank Don for his patience during my low BFO level issue. In
> the end, none of the normal fixes alone seemed to work. However, that problem
> was solved by changing a capacitor value in combination with the usual fixes.
> I did learn how critical the installation of the BFO toroid was for proper
> level and frequency range. Unfortunately, in my case, it was not quite enough
> in itself. All good now, though.
>
> I thought I did a good enough job installing C70. I did not. Sure enough,
> during some field day testing, I had the horrible distortion on signals around
> 7185 kHz. I shortened up the one lead on C70 just a little more. Problem
> solved!
> Do not leave ANY extra length on those leads!
>
> I am curious how others have dealt with the new tuning knob. It is a nice
> knob, but will not reach the felt pad on the front panel. I suppose you could
> stack a few pads, but you would need to fill at least a 3/16" gap. On my knob,
> I attached a thick brass disc that fits within the indentation on the back of
> the knob and is drilled out in the center the clear the shaft nut on the
> encoder. This fills the space behind the knob. Since the disc is smaller in
> diameter, it does not interfere with the display bezel. I was going the drill
> and tap the back of the knob and use countersunk screws on the disc to hold
> it. However, I super glued the disc to the knob to perform a temporary test
> and it did not want to come back off for drilling. I guess I do not need the
> screws after all.
>
> Overall, I have been enjoying this rig and have been very pleased with the
> performance and the amount of functions built into the programming. I was a
> little worried about spending a lot of money for such a basic radio, but it
> bothers me less every time I use it.
>
> Have a good day,
> Anthony
> n3kcb
>
>
>
>
>
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rcrgs at verizon.net
>

-- 
Robert G Strickland, PhD ABPH - KE2WY
rcrgs at verizon.net.usa
Syracuse, New York, USA