[Elecraft] K3s/WSJT-X 1.80rc1 TX issue

[Wes Stewart]

What are the settings on the "Audio" tab?

Mine are Input    : Microphone xxx USB Audio CODEC
                 Output: Speakers xxx USB Audio CODEC

Wes  N7WS

On 8/11/2017 7:30 AM, Serge Bertuzzo wrote:
> Hello to the group.
>
> I am receiving no problem at all. I am however having  difficulty in  getting
> WSJT-X to transmit. I am using a K3s.
>
> I have the K3s set up for Data A (USB) mode operation and have the MAIN:MIC Sel
> set to LINE IN.
>
> On the WSJT software Settings under the  <Radio> tab I have  selected the K3
> under Rig, set the serial port that I normally use for CAT control (COM 5 in my
> case), I have set PTT method to CAT, the set Mode to None, and set Split
> Operation to None. Not quite sure how to change the Transmit Audio source
> setting as it is greyed out. It is presently set for Front / Mic.
>
> If I hit the TUNE button on the WSJT software my transceiver goes into transmit
> mode but there is no output at all.
>
> Any help/guidance would be greatly appreciate. Thank you in advance.
>
> 73
>
> Serge
>
> VA3SB
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to wes_n7ws at triconet.org