[Elecraft] FW: Handles and feet

[Don Wilhelm]

I would cut a few pieces of 1/4 inch plywood and cover it with black 
fabric (contact cement, etc.).  Just put the pieces between the gear 
that need contact protection.

I do not personally have the problem, so this is just a suggestion for 
those who do.  If you normally use the tilt stand, cut the plywood so it 
is shaped to sit on the desk/shelf and the top is angled the same as the 
top of the equipment.  I would think the top of the plywood separator 
should be a bit below the top of the equipment.
Just an idea, implementation is left to "the student".

73,
Don W3FPR

On 4/22/2017 6:02 PM, Bill Johnson wrote:
> How about a small block under the soft handle? The handle would then easily protect another piece of equipment.
> 
> 73,
> Bill
> K9YEQ
> 
> -----Original Message-----
> From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Clay Autery
> Sent: Saturday, April 22, 2017 1:12 PM
> To: Erik Basilier <ebasilier at cox.net>; elecraft at mailman.qth.net
> Subject: Re: [Elecraft] FW: Handles and feet
> 
> I have given a "proper" spacing/protecting engineering solution serious thought on a number of occasions.
>