[Elecraft] KPA1500 feature added to KPA500

[Phil Hystad]

I do this now.  The memory saved values for power level are both for use with the
KPA500 off (standby) and on (off standby).  So, I have two saved memory values
for power level for the K3 for each condition (amp on, amp off).

73, phil, K7PEH

P.S. besides, I would hate to have the KPA500 reset my power level just because
it is on.  I may not always want the same drive with the amp.


> On Apr 21, 2017, at 4:45 PM, Marvin Wheeler <marvwheeler at nwlink.com> wrote:
> 
> 
> 
> Somewhere reading the information about the new KPA1500 I read that if the
> new amp was powered on it would cause the K3/K3S to automatically lower to
> drive the amp. Can or will this feature be added to the KPA500? I would be a
> welcome addition in my opinion.
> 
> 
> 
> Marv - KG7V
> 
> 
> 
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to phystad at mac.com