[Elecraft] Comm does not work after KIO3B installation

[Don Wilhelm]

Adde,

If you get any message at all on the computer, then the computer knows 
that "some" device is connected.
If that is the case, you may need to load the driver manually - download 
from the Elecraft website.
It is an FTDI USB to serial converter, and Windows 10 normally loads the 
driver properly.  I don't know about other versions or non-Windows OS.

73,
Don W3FPR

On 4/17/2017 4:11 PM, Adde Tjernberg wrote:
> Hi all!
> 
> I recently installed the KIO3B (the USB module) upgrade in my K3.
> 
> The K3 recognize the KIO3B board and I am able to choose "USb" under the
> CONFIG->RS232 menu settings.
> 
> However, when connecting the K3 to my computer, the computer does not "see"
> the radio. Nothing happens more than the computer says it does not
> recognize the device.