[Elecraft] [K3] No Power out, no sigs in

Geoff Allsup gallsup at whoi.edu
Sat Apr 15 20:27:46 EDT 2017


I had similar trouble related to the synthesizer boards on a K3. On the newer KSYN3A boards there is a green LED on the top edge of the board that should be ON if the board is working ok. You mentioned a sub RX so you should have two of these boards mounted against the back of the front panel.  

In any case, if the main KSYN3 board dies, everything acts as you've described. If the sub RX KSYN3 board dies, only the sub RX is affected. So there is a chance you could swap the KSYN3 boards and bring the main K3 back to life at the expense of no sub RX. 

Just a thought - bit of a pain to swap those boards. 

Geoff - W1OH 



Sent from my iPhone

Geoff Allsup, W1OH       gallsup at whoi.edu or w1oh at whoi.edu
Senior Engineer                         Upper Ocean Processes Group
Woods Hole Oceanographic Institution            Woods Hole, MA


> On Apr 15, 2017, at 19:33, Martin <dm4im at t-online.de> wrote:
> 
> Elecrafters,
> i'm on vacation at a /p qth and K3 #2878 has quit working.
> I have no power out. The display reads 0.0 watts when holding the tune button, regardless of mode.
> In RX I hear noise from the headphones , but no signals. The noise sounds like the K3 sounds when no antenna is attached.
> 
> I attached my antenna to RX-IN , no joy
> Also no signals on SUB-RX.
> 
> The only measurement gear i have right now is an ohmmeter and a powermeter.
> I have no programming cable right now.
> 
> I should have mentioned that i had power out briefly. but the cable of the headphones was very close to the ladderline , in fact touched it, when i checked match by holding TUNE.
> 
> Any advice what to check?
> 
> -- 
> 
> 73, Martin
> 
> Ohne CW ist es nur CB...
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to gallsup at whoi.edu
> 


More information about the Elecraft mailing list