[Elecraft] Has anyone recently got a K2 Kit with the NEW main Knob, Does it Fit?

[Cameron Francey]

Hi Harry,

I have my second  K2 which I got in the middle of January.

Both the knob on my earlier one, from June 2016 and the one from January 2017 is the same, and it fits perfectly.  The knob is the updated one which also ships with the new encoder assembly.


Hope that helps,


Cameron - AF7DK/GM7LQR



________________________________
From: Elecraft <elecraft-bounces at mailman.qth.net> on behalf of Harry Yingst via Elecraft <elecraft at mailman.qth.net>
Sent: Wednesday, April 12, 2017 7:26 PM
To: Elecraft Reflector
Subject: [Elecraft] Has anyone recently got a K2 Kit with the NEW main Knob, Does it Fit?


When I ordered my K2 (end of January) it came in with the old style knob not the one that was in the Errata sheet (same style as the KX3).


After a series of calls and e-mails I finally got Elecraft to send the knob only to find that it does not fit correctly as the encoder shaft

is too long so it sticks out from the front panel and does not engage on the felt washer. Additionally the knob is also too large (diameter
in the rear where it flairs out so it it did engage the felt washer it would rub on the Display bezel.


So my question is to those who recently got a K2 (NOT the KX2).
Did you receive a KX3 style Knob as per the Errata Sheet and if so does it fit correctly?


Thank you



.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to cameronfranceyutils at hotmail.com