[Elecraft] K3 slightly off frequency

[Bill Frantz]

There is a procedure in the manual under "Calibration 
Procedures". "Reference Oscillator". Using WWV can get you close 
enough for most uses.

73 Bill AE6JV

On 4/9/17 at 10:05 PM, elecraft at mailman.qth.net (Steve Wilson 
via Elecraft) wrote:

>A few of us in Fremont, CA have a weekly 10 meter net. I have a 
>friend with a K3 who always sounds off frequency. When I use my 
>K3, I've been told that I am off frequency. There are a couple 
>of KX3 users who don't seem to have a problem. When I use my 
>Kenwood TS-590 I seem to be on frequency.
>Is the K3 known, in general, for being slightly off frequency? 

-----------------------------------------------------------------------
Bill Frantz        | Privacy is dead, get over    | Periwinkle
(408)356-8506      | it.                          | 16345 
Englewood Ave
www.pwpconsult.com |              - Scott McNealy | Los Gatos, 
CA 95032