[Elecraft] DATA-A tx freq offset with digital modes

[Graham Alston]

Hi,

I’m very new to Elecraft and K3S so hope this is not too obvious….

I have a K3S connected to my PC with audio tones coming in via MIC IN (in reality the K3S is the remote end of a K3-Twin remote setup).

When I use DATA-A sub mode for CW, the transmission is 600Hz higher than the VFO frequency. I assume this is because DATA-A transmits on the USB and the VFO shows the suppressed carrier frequency?

I want my CW signal to match the VFO, how can I do that?

73, Graham VK3GA