[Elecraft] SWR question

[Mark E. Musick]

Where is the TX sensor located? It should be between the KPA500 and the
KAT500. It sounds like you have it in-line after the KAT500.

Mark, WB9CIF

-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Joe
K2UF
Sent: Wednesday, September 14, 2016 6:49 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] SWR question

Using my K3/KPA500/KAT500/P3+SVGA with the TX sensor in line. 
 
On the KPA500 the SWR reads 1.3  with one or two SWR led's  lit  also one or
two led's lit on the KAT500 but the SWR display on the P3 shows about 6.  
 
Any ideas why this is happening?
 
Joe K2UF    
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to markmusick at sbcglobal.net