[Elecraft] Thanks to all

[Nr4c]

What baud rate is K3 set to?  Should be USB if using the USB to USB cable. 

I don't think the computer will connect to the radio if radio is not ON. 

You do not use a KUSB with the KIO3B upgrade. 

You should also get the new P3 "Y" cable to connect the P3 to the K3. 

Sent from my iPhone
...nr4c. bill


> On Sep 10, 2016, at 8:12 PM, Louis Ives <hotrod541 at hotmail.com> wrote:
> 
> I would like to thank everybody that responded to my questions about upgrading my K-3.  All of the upgrades went without a problem, due in large part to the advise given. Everything works but   I have a strange working K103B. The only way it will connect to the K3 utility page is to connect my old KUSB cable to the cable that came with the K103B, (con3) and connecting to the RS232/P3 port. The new USB cable (con4) will not work no matter what I do. The configure menus shows that the K103B is being recognized.  I set it to NOR,  but I see that it can be set to HF-TRN or TRN also.  I hope that I have it set correctly. I checked my computer and it is listing port 4 as working correctly and is recognizing the new USB cable. I have also found that to connect to the K3 utility the K3 must be powered up.  The manual stated that it should connect to the utility regardless if it is powered up or off.  Any advise on this would be appreciated. 
> 
> PSent from my iPad
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nr4c at widomaker.com