[Elecraft] Dx Commander Settings for K3s

[iain macdonnell - N6ML]

On Fri, Sep 9, 2016 at 5:55 PM, Grady Harper via Elecraft
<elecraft at mailman.qth.net> wrote:
> What are the
> Baud
> Word
> Parity
> Stop
> DTR
> RTS
> Settings for the K3s

Per the K3[S] Owner's Manual, 8 data bits (word length), no parity and
1 stop bit (but the stop bit setting is probably not really critical).
The baud rate should be set to match the K3's CONFIG:RS232 setting.
RTS and DTR should be set to "Off".

73,

    ~iain / N6ML