[Elecraft] KPOD- POWER Macro

[Leroy Marion]

In a TAP position I have   TUNE5W    PC005;SWH16;      goes into 5W tune,
Tap again it goes to operate. 

In the corresponding HOLD I have  TUNE15W   PCO15;SWH16;   Goes to  5W
tune(I have the CONFIG TUNE PWR set to 5W), sets the drive level to 15W.
 TAP it again it goes to operate. That  gives me 475W out on 160mtrs. That
is TOO much drive for me on 6mtrs. 

Works for me. 

Leroy AB7CE

-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of 2EØLDZ
Sent: Tuesday, September 06, 2016 3:40 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] KPOD- POWER Macro

Message-ID: <b60b8d91-d879-6737-8c62-57c9ef6e34e7 at embarqmail.com
<mailto:b60b8d91-d879-6737-8c62-57c9ef6e34e7 at embarqmail.com>>

Leroy

I would be interested to see the macro that you are using to set the power.

I too would like to be able to toggle a higher and lower power at the push
of a button


73

Trevor Clapp
M6LDZ
2E0LDZ
LDZ at chopcat.co.uk <mailto:LDZ at chopcat.co.uk>

RADIO BLOG <http://chopcat.co.uk/page1/blog/index.html>

07900 49 77 11





______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to lmarion at mt.net