[Elecraft] K3-10 Rx sensitivity update

[Wes Stewart]

It's been my experience that this issue also affects TX output power.  My fix 
was to add a solder lug to the board side standoff screw and one to the SO239 
flange and solder a short buss wire between them.

On 10/28/2016 1:40 PM, Allen Bush via Elecraft wrote:
> Update on K3-10 Rx sensitivity problem ..... found the culprit.  The single standoff for the corner of the KANT3 board was loose between the standoff and the T connector by about a turn.  Wiggling the board around caused the noise to come and go.  Tightening the standoff cured the problem....Allen, W0OUU
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to wes_n7ws at triconet.org