[Elecraft] KX3 Macros commands

[Gerard Elijzen]

Hi all,

Just been playing with commands for the KX3 and found that when using the KX3 Utility on my MacBook Pro, that some commands don’t get a return.
For example: PO; always returns P0000 despite that the power has been set at 10W.
There are others as well which do not return anything after issuing a command to the KX3.

I am only just starting to look into the possibilities with Macros and I hope to make a Macro which will do (roughly) the following:

1. CW mode
2. set Power 100mW
3. sent message 1
4. Pause 10 seconds
5. set Power 1W
6. sent message 2
7. Pause 10 seconds
8. set Power 5W
9. sent message 3
10. go back to 2 or exit

Not sure if “a Pause can be done”.

Newbie here and just starting, testing and reading up with the KX3 commands.

Cheers
Gerard VK2JNG