[Elecraft] K3S with ACOM 1000 linear amp.

[Jim Brown]

On Tue,10/11/2016 1:57 AM, Alex Dokic via Elecraft wrote:
> i see the important info on controlling the drive power with the power control on the k3 and not using ALC, also the TX delay time may have to be increased a bit. I am not sure on the connection from the k3 to acom.

I ran a 1010 for a while for CQP, only on SSB, so I can't comment on 
delay time. A simple RCA to RCA connector from the K3 to the 1000 is all 
that is needed to key the amp. You are correct that ALC should NOT be 
used between the K3 and the amp. This is true of virtually ALL rigs and 
amps. Using ALC to set power is a recipe for splatter and clicks.

73, Jim K9YC