[Elecraft] K3 Memories VFO B

[James Kohnke (W6VAR)]

I just updated my firmware after being off the air for a long time. I used to save two frequencies in a memory...like 20m QRP and I would put CW in VFO A and SSB in VFOB.

For some reason, when I load a memory now, it does not update VFO B. When I read the memories from the K3 using the memory management software, it shows the correct VFO B frequency and mode. However, if I save a new memory on the K3 and read it with the software, VFO B is set to the same settings as VFO B.

Did this functionality quietly get stripped to scavenge more memory for other functions?

Jim W6VAR