[Elecraft] K3 - Can't hear 40m sigs in sub rx

[Don Wilhelm]

John,

Normally the P3 does not show signals from the subRX.  The IF out is 
only from the main RX.
Unless you have added an IF buffer amplifier and IF output to your 
SubRX, you will not see signals from the subRX on your P3.

73,
Don W3FPR

On 10/3/2016 10:55 AM, John E Bastin wrote:
> On Oct 3, 2016, at 10:19, Don Wilhelm <donwilh at embarqmail.com> wrote:
>> John,
>>
>> The most common cause of that problem is the SubRX antenna selection - that is a per band setting.
>>
>> Go to 40 meters and get into BSET - then tap the RX ANT button.
>>
>> If that does not restore proper operation, contact Elecraft support.
> I’ll check that, but it seems that if there was no antenna, there would be no signals in the sub rx on 40 meters, and I’m seeing the signals on the  P3, I just have no audio.
>
>