[Elecraft] K-Pod MCU 1.09 'F3 Power Up' Question

[Cady, Fred]

Hello Marty,

I don't remember seeing any response to your question so here is what I have found with my KPod:

The K3's tuning rate is determined by VFO CTS, FST and CRS and there are two fine rates (1 Hz and 10 Hz) and a course rate (100 Hz) depending on the FINE/COARSE switch.

So when my CTS is 200, the K3 tunes 200 Hz, 2 kHz and 10 kHz per revolution.

The normal power-on KPod tunes 100 Hz, 1 kHz, and 5 kHz per revolution.  (it divides by 2).

Holding F3 when power-on the KPod tunes 50 Hz, 500 Hz and 2.5 kHz per revolution (divide by 4).


Cheers,

Fred KE7X


For all KE7X Elecraft books, see www.ke7x.com<http://www.ke7x.com>

(A macro programming book is coming soon.)




________________________________
From: Elecraft <elecraft-bounces at mailman.qth.net> on behalf of Marty Koszewski <mtkoszew at gmail.com>
Sent: Monday, November 21, 2016 3:18 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K-Pod MCU 1.09 'F3 Power Up' Question

I installed the latest K-Pod firmware - MCU 1.09.   The release notes state "Adds a power-on feature: if the F3 button is held during power up the K-Pod encoder uses a divide by 4 scaling factor."    I do not notice any difference when powering up holding the F3 button.

What is the 'F3' power-up supposed to do?  I thought it might address the 4X VFO knob speed difference between the K3 and the K-Pod (my K3s VFO is still 4X faster than the K-Pod).

Thanks.

Marty - N1VH


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to fcady at montana.edu