[Elecraft] Low Line-In level

[Dragan 4O4A]

I have total of three cables (using two at the time, normally). I didn't make
them so I'm not sure if it is shielded or not, cables are with ferrite beads
next to the jacks, on both sides of cables. I have used those cables for two
years, never experienced any problem. Nothing changed in my setup recently,
I used this for both WSJT and RTTY ten days ago or so, and it was OK. When I
tried WSJT few days ago I found this behavior. 

Then I switched my RTTY operations to FSK (to "real" FSK, keying with serial
cable). 
I liked to use AFSK because of simplicity and I'm aware of importance of ALC
settings for clean signal.

I tried to switch cables, but no joy. Still the same. 




--
View this message in context: http://elecraft.365791.n2.nabble.com/Low-Line-In-level-tp7624013p7624096.html
Sent from the Elecraft mailing list archive at Nabble.com.