[Elecraft] KX3 Transmit EQ Settings

[Matt Zilmer]

Best is to eliminate the low (50, 100, 200 Hzbands).  These contribute 
nothing to intelligibility, and the MH3 has frequency response below 400 
Hz, so you'd just be wasting energy because of this.  With the low bands 
at 0dB, I got reports of muddy audio.

I would also suggest a mid-band boost, say at 1.6 and 2.4 KHz, of 3 to 5 
dB.  This will assist intelligibilityin general.

I'm using these settings on a K3, KX3, and on a KX2 with different 
microphones, and all of them produce excellent voice audio as reported 
on-air.

73,

matt W6NIA


On 11/9/2016 1:28 PM, k4mmg.ham at gmail.com wrote:
> Any suggestions on what EQ settings for good SSB communication using the Elecraft hand mic?
>
> Any suggestions on what EQ settings for good SSB communications using any other type of mike?
>
> I am not seeking any fancy audio profile.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to mzilmer at roadrunner.com

-- 
Always store beer in a dark place.  - R. Heinlein

Matt Zilmer, W6NIA
[Shiraz]