[Elecraft] KXPA100 RS-232 problem

[Don Wilhelm]

Tom,

If it were not for the addition of your loop control box, you would set 
both the KXPA100 and the KX3 to the 38.4 rate.
But take a look at the baud rate requirements for your loop control box. 
  If it will handle 38.4k, then all is well, but if it requires a lesser 
baud rate, set both the KX3 and the KXPA100 to that baud rate.

73,
Don W3FPR

On 11/4/2016 10:34 AM, Thomas Beltran wrote:
> Hello John and thanks.  Should I figure out what the baud rate of the kx3 is
> (since that works) and then set the kxpa100 to match?
>
> -----Original Message-----
> From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of John
> Pitz
> Sent: Friday, November 04, 2016 7:23 AM
> To: elecraft at mailman.qth.net
> Subject: Re: [Elecraft] KXPA100 RS-232 problem
>
> It is likely a RS232 speed issue like Dick Dievendorff said.  Something else
> you may want to do is change the KX3 baud rate to match the KXPA100.  The