[Elecraft] P3 SVGA problem

[Dave Cole]

Hi Bill,
No, no external monitor is used...  You should see a message pop up on
the P3 screen, indicating a USB device has been plugged in, when you
plug in a keyboard.  If this does not happen, and you are sure you are
using a dumb keyboard, not a multimedia keyboard, then something is
either not set up correctly, or broken.  If setup might be the issue,
look in Cady's book, if broken, give Elecraft a call...  It has been
too long for me to remember if setup can break this...

-- 
73's, and thanks,
Dave (NK7Z)

For software/hardware reviews see:
http://www.nk7z.net

For MixW support see:
https://groups.yahoo.com/neo/groups/mixw/info

For SSTV help see:
http://groups.yahoo.com/neo/groups/MM-SSTV/info


On Sun, 2016-05-15 at 09:28 -0400, Bill wrote:
> I installed the SVGA board in my P3 and am unable to access the
> terminal 
> mode. In effect, the P3 operates as it always did prior to the SVGA 
> installation - nothing is new. I have installed the latest firmware
> - 
> for the entire station.
> 
> I only bought the SVGA for macro uses - hence, did not plan to have
> an 
> external monitor installed. Is an external monitor required for this 
> purpose?
> 
> Thanks,
> 
> Bill W2BLC K-Line
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dave at nk7z.net