[Elecraft] KPad and P3

[Bob Novas]

I'm really interested in the KPad, but specifically for use with the P3. The
K3/K3S already has a nice knob!  I like to use the P3's knob to tune to a
signal and then push the P3 knob in to set the K3S receiver to that
frequency.  Most of the time I can very accurately hit as SSB signal, if I
turn the P3 knob to the correct side of an SSB signal and simply assume that
the carrier is at xxx0.0 kHz. But the P3 knob is small and that makes this
hard to do.  I think it would be great if you could do this with the KPad
knob, and one of the KPad buttons. 

 

But, I called Elecraft and spoke to tech support and they said the KPad
wasn't being programmed to work with the P3, but that this reflector was a
great place to post feature requests. Do any others want to chime in and
request this feature?  Thanks, Bob   - W3DK