[Elecraft] K3S RJ-45 Pin Alignment

[Kevin Stover]

I agree with Don. Try a new cable.

It doesn't take a lot of flex to break one of those small solid copper 
wires.
If it's broken in the connector it wasn't crimped well, as the standard 
RJ-45 has a strain relief built in that clamps down on the cable to keep 
it from pulling out.

I just cringe when I see someone unpack a store bought cable, grab a 
hold of the connector and start straightening it out.

On 5/1/2016 6:04 PM, Don Wilhelm wrote:
> Byron,
>
> You might have a defective cable - get another one and see if the 
> problem goes away.
>
> 73,
> Don W3FPR
>
> On 5/1/2016 6:59 PM, Byron Peebles wrote:
>> I have indeed done all the clicks and boot removals and been unable 
>> to resolve the disconnect.
>>
>> It even happens when the radio is in-use and suddenly has the radio 
>> disconnect from the computer.
>>
>> So, the only answer is the standard "make certain it clicks", which 
>> it does?
>>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to kevin.stover at mediacombb.net
>


-- 
R. Kevin Stover
AC0H
ARRL
FISTS #11993
SKCC #215
NAQCC #3441


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus