[Elecraft] K2 encoder kit 4 pin connector

[Rick WA6NHC]

Resin would be difficult to remove should the need arise.

How about a thin piece of cork, often used in crafts?

Rick nhc

On 3/23/2016 11:57 AM, lstavenhagen wrote:
> Actually, I just checked mine after finishing the flush cutting and the
> boards are going to touch when they're screwed together.
>
> In the archives it was suggested to use electrical tape, but I'm thinking a
> more durable solution might be a thin layer of resin on the daughterboard as
> a more permanently attached insulator. Any thoughts?
>
> Tnx es 73,
> LS
> W5QD
>
>
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/K2-encoder-kit-4-pin-connector-tp7615471p7615483.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to wa6nhc at gmail.com