[Elecraft] K2 encoder kit 4 pin connector

[lstavenhagen]

Hi Don, 
Ok thanks for the info. Whew, that's good because I managed to ruin it
anyway having made a mistake with it that I'm too ashamed to admit to on the
reflector hi hi.

And thanks for the warning about flush-cutting the daughter board. In fact,
I did find some discussion of this in the archives so I went over mine with
my flush cutters last night and got all the nubs as close as possible to the
board. The manual describes putting the lock washer under the standoff also
- maybe this was a change in the new manual? In any case, I checked the
clearance with a straightedge over the two standoffs this am too and it's
veeeery close hi hi. So I'll be careful with this at assembly once I get to
that point.

I don't remember this on my first K2 which is #6882 I think. Maybe it had a
different encoder? I'm too lazy to take it apart to look hi hi.

On to the RF board now. I'd forgotten what fun this kit is to build!

73,
LS
W5QD



--
View this message in context: http://elecraft.365791.n2.nabble.com/K2-encoder-kit-4-pin-connector-tp7615471p7615478.html
Sent from the Elecraft mailing list archive at Nabble.com.