[Elecraft] P3 - Control from Python Gui

[a45wg]

Fellow Hams,
	I have found time to update the P3 Controls - it is now fully GUI - and you can have any type of split (not negative !!) with a p3 bandwidth of up to 10Khz, with the carrier at any offset you want from (0-5khz)

	The code is in my github page at https://github.com/timseed/Elecraft-K3-Pan-Pile-Up-Settings <https://github.com/timseed/Elecraft-K3-Pan-Pile-Up-Settings>

	It now however requires QT5 (which can be troublesome on certain days of the week to install) - but once installed - a few more packages (numpy, pyserial, guidata) and you are done.

	If anyone requires any assistance with this - please PM me off-list.	

	Regards

		Tim	- A45WG