[Elecraft] P3SVGA/K3 macro madness

[Dave Cole]

K2UF,
Looking at your cut, you left off the ";" at the end of the command.
 Each command needs the ";" at the end.
-- 
73's, and thanks,
Dave

For software/hardware reviews see:
http://www.nk7z.net

For MixW support see:
https://groups.yahoo.com/neo/groups/mixw/info

For SSTV help see:
http://groups.yahoo.com/neo/groups/MM-SSTV/info



On Tue, 2016-03-01 at 17:44 -0800, Alan wrote:
> What version of P3 firmware is installed?  You need at least v. 1.57.
> 
> Alan N1AL
> 
> 
> On 03/01/2016 12:59 PM, Joe K2UF wrote:
> > Trying to use the commands in the P3 pgmrs ref.   If I enter a
> > command into
> > the P3 utility or the K3 utility app they work fine.  If I try to
> > place one
> > of the P3 commands (ie  #SPN000500 ) in one of the P3 slots using
> > the
> > attached keyboard it does not work.  I do not have a problem using
> > any of
> > the K3 commands.
> > 
> > Any ideas/help
> > 
> > Joe  K2UF
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dave at nk7z.net