[Elecraft] KX3 power on sequence

[Bob N3MNT]

I too am a little confused as to "Complete power down".  If you do not shut
the KX3/KXPA100 down using the power off buttons ( band /autotune) but shut
down the external power source, the KX3 senses that and switches to internal
bat if installed.  This switches the power out to below 10W which sets PA
off.  When the KX3 is finally shut down it remembers it's last state and
comes up as PA off.  I have both KX3 and KXPA100 on same supply.  I turn on
supply then then KX3 which after boot sequence turns on KXPA100.  Not sure
if this will help, but I have seen what you are experiencing when the power
is accidentally shut down before shutting of KX3.  



--
View this message in context: http://elecraft.365791.n2.nabble.com/KX3-power-on-sequence-tp7614806p7614813.html
Sent from the Elecraft mailing list archive at Nabble.com.