[Elecraft] K-Pod owner's manual?

[Bill W4ZV]

Bob-2 wrote
> How?
> 
> Are you a beta tester?

Yes.  Short summary - the mod is simple IF you have the right parts.  Solder
a 6.8 ohm resistor across R82 (i.e. in parallel) on the Front Panel Board. 
No need to remove any panels but unscrew the 3 top and 2 bottom screws
holding the FPB to the chassis and then use a flat head screw driver in the
2 bottom slots to pry FPB apart from chassis.

Elecraft provides both 1/10 W SMD (0603 size) and leaded 1/8 W resistors in
the kit.  0603 SMD is a bit of a challenge but makes a very neat
installation if you're experienced with soldering SMD, or Elecraft will
install the mod for you if you email k3support at elecraft.com or call
831-763-4211.

73,  Bill  W4ZV




--
View this message in context: http://elecraft.365791.n2.nabble.com/K-Pod-owner-s-manual-tp7619352p7619362.html
Sent from the Elecraft mailing list archive at Nabble.com.