[Elecraft] KX3 SDR

[Lyle Johnson]

Sorry, I was thinking of the KX2 which always has the IF shift enabled.

In a KX3, the center of the IQ stream is approximately the dial setting. 
I say approximately because some modes (AM, FM) or submodes (narrow SSB 
using Weaver demodulation) there may be some offset regardless of the 
setting of IF shift.

Thank you for your careful reading, Greg!

73,

Lyle KK7P

>> The signals at the IQ jack on the KX3 are analog, not digital. They
>> are centered approximately 8 kHz away from the dial frequency as the
>> KX3 uses an internal offset of 8 kHz.  Depending on the firmware
>> release and user settable options, that offset may be on either side
>> of the center of the IQ audio.
> Do you mean always 8 kHz off, or is this only if the IF shift is
> enabled?  I would expect a 0 offset without that.
>