[Elecraft] KAT-500 Bypass indication/operation issue

[w4sc]

Misspoke, I meant "BYPASS" LED
Ben

-----Original Message----- 
From: Dick Dievendorff
Sent: Friday, July 22, 2016 12:57 PM
To: 'w4sc'
Cc: elecraft at mailman.qth.net
Subject: RE: [Elecraft] KAT-500 Bypass indication/operation issue

When the ATU TUNE function discovers the SWR is less than the bypass 
threshold, it should select "bypassed" as the tuning solution, and the 
KAT500 Utility should show no L or C values selected.  It should also show 
the "bypassed" check box.

I don't have a "standby" LED.

The "BYPASS" LED means that the ATU's mode is "BYPASSED", not that the 
current ATU tuning solution is "Bypassed".

73 de Dick, K6KR





-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of w4sc
Sent: Friday, July 22, 2016 09:09
To: Elecraft <Elecraft at mailman.qth.net>
Subject: [Elecraft] KAT-500 Bypass indication/operation issue

When SWR is less than 1.3 (factory default), the KAT-500 should go into 
“BYPASS” as I understand.

The LC values and MODE (Manual) from the previously selected antenna are 
still shown in the config utility “Operate TAB”.

Also, the STANDBY LED has never illuminated when the SWR measurement is less 
than the threshold set for entering the BYPASS mode.

Firmware installed

    K3:  5.38
    KAT-500: 1.67

de Ben W4SC


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message 
delivered to dick at elecraft.com