[Elecraft] K3 erratic VFO

[graham.wood1 at mypostoffice.co.uk]

Hi Chris,

A few months ago I updated the K3 (sn5845) firmware from 5.29 to 5.38.

I started to have a similar experiences, VFO's jumping Freq etc. I was given similar advise, to try working backwards removing newly installed boards and reinstalling them.

Before trying this I decided to go back to firmware 5.29 and last known working config file. This completely cured the problem and K3 is still working fine, so far not plucked up courage to try updating to 5.38 again.

If your problem started after updating your firmware, try going back to previous version it might solve the problem.
best of luck Chris.

73's Gray G3VIP