[Elecraft] KRC2 not working after PA upgrade

[Don Wilhelm]

Dave,

AFAIK, the addition of the KPA3 should not have any effect on the 
operation of the KRC2.

Check the jumpers in the KRC2 against the AUXBUS configuration for the 
K3 on page 23 of the KRC2 manual.
The two indications of K3 menu for the KRC2 show "-" and the "Turn On 
PA" message are making me think that there is some kind of conflict on 
the AUXBUS signal internal to the K3 or KRC2.

73,
Don W3FPR

On 1/25/2016 4:42 PM, Dave Glenn wrote:
> I recently had the 100 Watt amp added to my K3.
>
> I went to set it up with and use with my transverters and KRC2 menu item
> shows -
>
> Cabling looks good going from 15 pin on the K3 to the 9 on the KRC2.
>
>   
>
> If I power cycle the KRC2 while the K3 is on it shows Turn On PA and is
> locked up.
>
>   
>
> Is there some setting I have forgotten?
>
> Tnx, Dave N6TEB
>
>   
>
>   
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to w3fpr at embarqmail.com
>