[Elecraft] P3 Macro question

[David Cole]

That is exactly what I am attempting to do here, Hence my question as to
why I am unable to get the P3 to take a macro via the USB port...  I
want it on the Genovation keypad, not the P3 case.
-- 
Thanks and 73's,
For equipment, and software setups and reviews see:
www.nk7z.net

For MixW support see;
http://groups.yahoo.com/neo/groups/mixw/info
For Dopplergram information see:
http://groups.yahoo.com/neo/groups/dopplergram/info
For MM-SSTV see:
http://groups.yahoo.com/neo/groups/MM-SSTV/info


On Sun, 2016-01-24 at 10:21 -0800, Bill Frantz wrote:
> With this facility, I would consider using a micro controller to implement two functions:
> 
>   P3 for split mode: Read VFOs A and B. Set center and span so A
>   and B VFOs are on opposite sides of the display. To use, tune
>   in the DX on A and put B just above the pileup. Press the
>   button.
> 
>   P3 for band scanning: Band edge aware setup for fixed spans,
>   e.g. 50KHz, 100KHz 200KHz. Read VFO A. Set span to the fixed
>   span. Set the center so the VFO is near the center of the
>   display and the lower edge is a multiple of half the span above
>   the bottom edge of the band.
>   
> 73 Bill AE6JV
> 
> On 1/24/16 at 9:14 AM, dave at nk7z.net (David Cole) wrote:
> 
> > ... is there a way to trigger the P3 to accept a macro designed for
> > the P3 itself, using the rear USB connector on the P3?
> > 
> > In essence, I want to be able to control the P3 via it's own macro set
> > using the USB connector in the rear of the P3 itself.  Is this possible?
> 
> -----------------------------------------------------------------------
> Bill Frantz        |The nice thing about standards| Periwinkle
> (408)356-8506      |is there are so many to choose| 16345 Englewood Ave
> www.pwpconsult.com |from.   - Andrew Tanenbaum    | Los Gatos, CA 95032
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dave at nk7z.net