[Elecraft] K3 - KIO3B setup

[Bill Conkling]

Well, first, I don’ recognize the CBLP3T cable.  Maybe you meant CBLP3Y? If so, I think yu would still need a DE-9 “Y” cable to connect at the P3 at which ever port you used before (TXCVR or PC).

Be sure to set CONFIG:RS-232 to USB and not 38400 as before.  And now your audio input/output is the new USB CODEC.  Have fun and let us know how it works.

…bc  nr4c




> On Jan 18, 2016, at 4:24 PM, N2TK, Tony <tony.kaz at verizon.net> wrote:
> 
> I installed the KIO3B kit. I have it set up as the original KIO3 - K3- RS232
> to P3 to PC/SteppIR. Accessory plug with FSK interface and audio in and out
> cables to audio board. I use LP-Bridge. Everything is working fine as it was
> before the upgrade.
> 
> Now I want to take advantage of the features of the KIO3B kit.
> 
> 
> 
> I have the CBLP3T cable for the K3 to the P3. 
> 
> I will replace the RS232 with the USB to the PC.
> 
> I will remove the audio in and out cables. 
> 
> 
> 
> Is there anything special I need to do now that I will be using a USB port
> instead of the RS232? 
> 
> What about with LP-Bridge? Anything I need to do with it? 
> 
> Where is the best place to hook up the SteppiR now that I don't have an
> RS232 connecting to the PC?
> 
> 
> 
> Tnx for any feedback.
> 
> 73,
> 
> N2TK, Tony
> 
> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nr4c at widomaker.com