[Elecraft] P3/SVGA help..

[Paul Saffren N6HZ]

There are LEDs on the P3 front panel and on the SVGA board, both should be
blinking.  If you plug a keyboard or USB thumbdrive into the SVGA board, you
should see another LED light up on the SVGA board. 

The next thing to try is a parameter reset on the P3.  Do that holding down
the MENU key and then tapping the POWER key.  This will reinitialize any
settings so you may first want to save the P3 configuration using the P3
Utility.  

Next check the revisions of the all the FPGA files located on the SVGA
board.  You mentioned that you upgraded the firmware, but maybe one of these
files could be corrupted (they control the video chip).  Rotate the encoder
to the SVGA sub-menu and then enter it.  Rotate the encoder to select SVGA
FW and select using a push of the encoder.  You should see 1.04 in FPGA 0 to
FPGA 4.  

If none of that works, email me directly at Elecraft.  My email address is
pauls at you know where dot com. 

Kind regards, 

Paul



--
View this message in context: http://elecraft.365791.n2.nabble.com/P3-SVGA-help-tp7612682p7612690.html
Sent from the Elecraft mailing list archive at Nabble.com.