[Elecraft] Starving" Fldigi for audio Rx

[Joe Subich, W4TV]

Are you sure you have configured fldigi to use the correct sound
device? With my K3 set to CONFIG:LINE OUT = Nor 10, microHAM
interface with the RX MAIN pot at ~ 10:00, and "Line (microHAM
CODEC)" level set to 80% in the Windows Sound Control panel
(Recording Devices) - Windows 10, there is no "starvation" (clean
square waves visible) in the fldigi "scope" view.

73,

    ... Joe, W4TV


On 1/13/2016 4:02 PM, paul ecker via Elecraft wrote:
> In response to my question on the Win- Fldigi Reflector that I asked regarding waterfall adjustments and the fact that I was seeing no signals on the Fldigi Scope, Dave W1HKD  responded,--- If you need those controls set to the maximum range and lowest absolute signal (or close to it) then you are probably starving Fldigi for Rx audio--
> So my question  concerns Dave's comment that I am "Starving" Fldigi for audio Rx.  Do other K3/ Fldigi users when operating in PSK 31 mode see any signals on the Scope view? I have tired adjusting the Rx pot on my DK II and Windows - Sounds- Recording -Levels with no change.. in Fldigi. I am able to decode signals.What settings on the K3 affect Rx audio to Fldigi?
> (Setup:Win 7 PC, micoHam DKII interface.)
> 73 Paulkc2nyu
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to lists at subich.com
>