[Elecraft] and now something completely different.. the w2

[Brian & Cyndi]

1. Not possible. The two sensors feed into an electronic switch that 
connects one sensor at a time to the microprocessor/LED bargraph display.

2. See the "W2 Owners Manual Rev D2", available on the Elecraft website. 
On page 5, "Important note" #5, it describes how to put the W2 into 
"search" mode. The W2 will automatically connect to the sensor getting 
RF. I wouldn't recommend allowing *both* sensors to be hot; CW or SSB 
will cause the sensors to switch rapidly and the resulting display would 
be meaningless.

73,
Brian, W6FVI

On 2/23/2016 7:18 AM, Chris Tate - N6WM wrote:
> I have installed a number of W2 watt meters in a large contest station in the bay area.  In general this has worked out real well, but now that I am setting up a second SO2R position I need to ask if anyone has either written some software or if it is at all possible to
>
>
> 1.        Observe data from both sensor 1 and 2 at the same time
>
> 2.       Switch without manual intervention (pressing the button) between sensor 1 and 2.
>
> If anyone has an intuitive solution to this so I don't have to move to 2 physical watt meters it would be great.
>
> Apologies if this has been discussed at some point in the past.
>
>
> Thanks
> Chris
> N6WM
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to w6fvi at sbcglobal.net
>