[Elecraft] K3s & CBLP3Y to P3 - no signal does follow VFO

[Ron D'Eau Claire]

Did you remember to connect the coax cable between IF IN on the P3 and IF
OUT on  the K3? 

If so, check that cable for opens or shorts.

73, Ron AC7AC



-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Gary
Smith
Sent: Friday, February 19, 2016 1:55 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3s & CBLP3Y to P3 - no signal does follow VFO

Hi,

I just connected the CBLP3Y cable to the P3 & K3s. The frequency shows on
the P3 & the SVGA monitor but I see no signals on the waterfall. It was
working fine with the K3 when I disconnected it and it is now not working. 

I do have RS232 configured to USB and I have made sure the jack & plug have
mated with a click on the K3.

Ideas of what I need to do to get the waterfall working?

Thanks & 73,

Gary
KA1J
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to ron at elecraft.com