[Elecraft] XG50 Signal Source for KX3, Assembled

[James Bennett]

The XG50 has been sold. Thanks to those who responded.

Jim / W6JHB


> On   Sunday, Feb 14, 2016, at  Sunday, 11:48 AM, James Bennett <w6jhb at me.com> wrote:
> 
> I’m selling my XG50 Signal Source. Per the Elecraft web page: “The Elecraft XG50 is a simple 49.380 MHz signal source specifically designed for use with the KX3 Extended VFO Temperature Compensation Procedure.”
> 
> This was purchased as a kit from Elecraft in January of 2014 (invoice supplied) and assembled by me. It works perfectly, and was used to do the thermal compensation procedure on my KX3. I’ve recently purchased the Elecraft XG3 RF Signal Source and therefore have no need for the XG50.
> 
> It comes with a two foot long power cable that has an Anderson Power Pole connector on one end and the 2.1mm power connector on the other end. Also supplied is the single page “assembly manual” that came with it.
> 
> Please reply off-list if you are interested. I can accept PayPal, personal check, or good old US cash.
> 
> Only available to US buyers, sorry. 
> 
> Asking $35, shipped for free to any US address.
> 
> Thanks, Jim Bennett / W6JHB at ARRL.NET
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to w6jhb at me.com