[Elecraft] K3 KIO3B - FSK - stereo

[N2TK, Tony]

Rich,
Thanks for your input. I had to go to the Mike input with the Codec and
change to 2 channel. That took care of the issue.

73,
N2TK, Tony 

-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of
Richard Ferch
Sent: Friday, February 12, 2016 4:54 PM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] K3 KIO3B - FSK - stereo

Here is something to check:

Right-click the speaker icon in the Task Bar and select Recording devices.
In the Sound window select the USB Audio Codec and click on Properties. In
the Properties window click on the Advanced tab and check the Default
Format. If it is set to 1 channel, ... change it to 2 channel, ... .

Also, make sure that the USB Audio Codec is not selected as the Default
Device or the Default Communications Device - these should both be set to
the motherboard sound card in your PC.

You should see main RX audio in the left channel. If the subRX is off, you
might see a bit of leakage from the left channel in the right channel, but
if the subRX is on you should only see subRX audio. When you are
transmitting, if your Monitor level is non-zero you should see the
transmitted signal in both channels.

73,
Rich VE3KI


N2TK wrote:

> Trying to setup the CODEC on the KIO3B. Is it stereo that it will allow me
> to do what I am presently doing for two channels?
>
> When I select Microphone (4-USB Audio CODEC) for both MMTTY's, I get the
> same signal on both MMTTY's. The second receiver has no impact.

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to tony.kaz at verizon.net