[Elecraft] K3 Missing CONFIG:WMTR after update to MCU5.38

[Wayne Burdick]

Bill,

Do you have TECH MD set to ON?

Wayne
N6KR


On Feb 7, 2016, at 8:55 AM, Bill Cotter <n4lg at qx.net> wrote:

> Hi,
> 
> I just updated my K3 (sn#3082) to the (MCU 5.38, FPF 1.25, DSP1 2.86) and performed the required TX Gain Calibration. The 5W calibration matched the Bird wattmeter on each band, but the 50W was over 50W on each band.
> 
> I wanted to calibrate the K3 wattmeter so I could repeat the process, however, when holding the CONFIG button, then seeking WMTR, it never appears. I see VFO OFS then XV1 ON, and no WMTR in between.
> 
> Suggestions??
> 
> Thanks - Bill N4LG  
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to n6kr at elecraft.com