[Elecraft] K3 and SDR-IQ and CW Skimmer
tomb18
tomb18 at videotron.ca
Fri Dec 23 03:13:48 EST 2016
You can connect the sdrplay to the IF out of the K3 and use Win4k3suite or hdsdr to view the spectrum. The Sdrplay would need to be tuned to 8.215MHz in HDSDR or it is tuned automatically in Win4k3.the SDRPLAY will provide 2mhz bandwidth in its most useful configuration but you can go to 8mhz bandwidth.On the K3, you will see some interesting effects as the bandwidth is increased. Depending where you tune you can see signals all of a sudden disappear when you tune the radio when the bandpass filters take effect. None the less 1.8 mhz is good on the ham bands.73 Tom va2fsq.com
Sent from my Samsung Galaxy smartphone.
-------- Original message --------From: Don Wilhelm <donwilh at embarqmail.com> Date: 2016-12-23 2:02 AM (GMT-05:00) To: Ignacy <no9e at arrl.net>, elecraft at mailman.qth.net Subject: Re: [Elecraft] K3 and SDR-IQ and CW Skimmer
Ignacy,
I know nothing about the display capabilities of SDR-IQ, so the only
thing I can say is that the actual input frequency of SDR-IQ must be the
same as the IF frequency of the K3 - 8215kHz.
73,
Don W3FPR
On 12/22/2016 3:52 PM, Ignacy wrote:
> I am trying to set up CW Skimmer with SDR-IQ and K3 so that SDR-IQ is
> connected to IF OUT and follows K3's frequency. Is this doable?
>
> If not, it there any way of configuring SDR-IQ to follow band changes with
> K3?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to tomb18 at videotron.ca
More information about the Elecraft
mailing list